E-Style Tubing Rotator

Applications

• Beam pumping operations
• PC pumping wells

Features

• Very low maintenance required
• Simple installation and removal
• Adds only 3 ¼” (20.6 mm)  to wellhead design
• Replaces the conventional hanger
• Maintains well control while stripping blow-out preventers (B.O.P.’s)

The Evolution E-Style Tubing Rotator system (also known as the ‘Eliminator’) was developed as part of a system primarily designed to extend the life of production tubing in beam pumping and PC pumping wells.

Using a Tubing Rotator can extend the life of down-hole tubing by up to ten times in certain circumstances; by equalizing the tubing wear around the entire ID of the tubing instead of wearing through in a single spot.

To use the E-Plus Tubing Rotator, the conventional hanger is replaced with a rotational model.  Evolution offers rotational hangers in A-style, CT-style, F-style and H-style.

Operation

The Evolution Oil Tools E-Style Tubing Rotators are available with three (3) drive options:

Manual Drive

The Manual Drive System allows the operator to rotate the tubing string on a periodic basis (typically daily or weekly).  This system is typically used with progressive cavity pumps.

Mechanical Drive

The Mechanical Drive System is used with pump jacks.  This system can be set up to allow for approximately one revolution of the tubing in a 24 hour period.

Electric Drive

The Electrical Drive System is used with progressive cavity pumps that have an electrical surface drive.  The drive system is run by an explosion-proof 220V motor. This system rotates the tubing string approximately two times during a 24 hour period.